...
 | new batch |  | close workspace or batch |
 | open (workspace or batch) |  | start event generation (workspace or batch) |
 | save |  | stop event generation (workspace or batch) |
The batch environment, as shown in Figure 28 consists of 3 panels (#1), identification, control and Workspaces.
...
 | New workspace to add in the batch |  | Remove a workspace from the batch |
 | open a workspace to the batch |  | Duplicate a workspace inside a batch |
 | Save a workspace |
|
|
When you open several workspaces from are opened in the batch mode environment, you parameters can change your parameters be directly modified in the workspace with an unlimited number of times by adding new simulations to the batch schedule until the intended variation of input parameters is fully covered by all entries.You have the possibity
It is also possible to save workspace results automatically after completing their simulation.
...
Batch results (Figure 29 #1) are available when the batch simulation is started. A result tab (#2) is by default active indicating the progress of the batch work (#3) and provides interference calculation engine capability (#5). When you press When pressing the analyse button the ICE is activated and the probability of interference is displayed (#6).
...
Figure 31: Batch results environmentAnchor F031 F031
If you have selected the “debug mode” is selected and still run a batch is run, the batch will stop until you close the log window is closed.