Page Comparison

Anchor
12.5.2 12.5.2

Once SEAMCAT has completed the simulation, the results are shown as displayed in Figure 261, when the CDMA network is the victim. This figure presents the difference between the 2 steps power balancing process (1-initial power balancing, 2- power balancing after introduction of an external interference), that is to say " non-interfered capacity " is the number of UEs in the victim network prior to adding an external interferer and "interfered capacity" is the number of UE in the victim network after adding the external interference.

...

When the CDMA system is the interfering link, the total received power at the receiver in the victim link, due to the transmit power of all the active mobile stations in the three cells of the center cell site of the CDMA cluster, adjusted for spectral masks, etc., is counted as the interfering power in the victim link.  Therefore, it is not necessary to keep track of any capacity loss in this case, unless the victim link is also a CDMA system.

Anchor
F261 F261

Figure 261: Example of the CDMA results display panel

Anchor
F262 F262

Figure 262: Example of the CDMA results display panel

...