| Anchor | ||||
|---|---|---|---|---|
|
Figure 107: Activation of the overloading feature in SEAMCATAnchor F111F107F111 F107
...
The overloading mask is expressed in power (dBm) versus frequency offset (MHz) and is defined as a function in SEAMCAT.
Figure 108: Setting of the overloading mask in SEAMCATAnchor F112F108F112 F108
...
Note that if the blocking attenuation mode in user-defined and the overloading feature have been selected, then a consistency check will remind you that the actual blocking response and the receiver filter are the same element and they should not be accounted twice.
Figure 109: Example of filling the Rx filter functionAnchor F113F109F113 F109
...
As an example, this means that for the following overloading mask presented in Figure 3 with a victim frequency of 908 MHz and an interfering frequency of 900 MHz, the delta frequency (i.e. frequency offset) is -8 MHz with an overloading treshold of -8.5 dB and a Rx filter value of 9 dB. This can be found from the log file as shown below in Figure 110.
Figure 110: Output from logfileAnchor F114F110F114 F110
