Page Comparison

...

Anchor

	6.5.1
	6.5.1

In such a scenario, the detection threshold is taken to a value of 0 dB (Figure 160) much higher than the sRSS level (average = -82.09 dBm) (Figure 161). Therefore, no victim system has been detected and the WSDs are allowed to transmit in any of the specified channels (Figure 162) per event.

Image Removed

Image Added

Image Removed

Image Added

Anchor

	F164F160F164
	F160

Figure 160: Selection of a high
detection threshold

Anchor

	F165F161F165
	F161

Figure 161: The sRSS values are well below the

detection threshold, so no victim system have been detected

In such a case the e.i.r.p.used in the simulation is the Tx_power (=-33 dBm) + G_max (=0 dBi), meaning that the in-block e.i.r.p. limit does not apply. This means that whatever the frequency selected by the WSD its e.i.r.p.. is the same (Figure 168164) (here assuming that the Power Control at the It is OFF).

Image Removed

Image Added

Image Removed

Image Added

Anchor

	F166F162F166
	F162

Figure 162: The WSD can transmit anywhere

in the victim frequency range

Anchor

	F167F163F167
	F163

Figure 163: e.i.r.p. set to -33 dBm as set in the It, i.e.

Txpower (=-33 dBm) + Gmax (=0 dBi),

meaning that there were no limit applied to the It Tx power

...

Figure 165 illustrates that on average there are 1.17 WSDs active at 1000.5 MHz per event, 1.23 WSDs in 1001.5 MHz, 1.34 WSDs in 1002.5 MHz and 1.26 WSDs in 1003.5 MHz for the same out of 5 which were input to the simulation. In this case all the WSDs were active (but in different frequencies) since the sum equal to 5 (i.e. none of the WSDs have been turned off).