...
Figure 124 presents the GUI with the input value.
Figure 124: Setting up the simulation radius in SEAMCATAnchor F124 F124
(Note that the results of the simulation radius is displayed only after running simulation)
The simulation radius is calculated by using the following formula:
...
Figure 125: iRSS using the simulation radius for 1 active transmitter (R=0.178)Anchor F125 F125
Figure 126: Calculated simulation radius with 1 active transmitterAnchor F126 F126
...
Then the iRSSunwanted should be above -24.5 dBm as shown on Figure 128.
Figure 127: Setting up the simulation radius in SEAMCAT with a different Anchor F127 F127
number of active transmitters
Figure 128: iRSS using the simulation radius calculated for 10 active interferers (R=0.564 km)Anchor F128 F128
Figure 129: Calculated simulation radius with 10 active transmittersAnchor F129 F129
...