Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

For simplification, we consider that the Victim link receiver and the Interefering link transmitter are defined using the following assumptions (1 km distance between the Victim and the Interefering link transmitter). This is illustrated in Figure 138134.

Anchor
F138
F138
Figure 138134: Setting up the distance between the Interfering and the Victim pair of
transmitter and receiver

 


If the power control is not activated then the iRSSunwanted is (see Figure 139135):

 

iRSSunwanted = 33 (dBm) + 11 + 9 - (32.5 + 10 log(1) + 20 log(1000)) = -39.5 dBm                      

Anchor
F139
F139
Figure 139135: iRSSunwanted without power control

 


The same assumption is used for the distance between ILT and the ILR (i.e. x = 0 km and y = 1 km) where the ILT is the (0,0) origin as shown in Figure 140136.

Anchor
F140
F140
Figure 140136: Setting up the distance between the Interefering link Interfering link transmitter and the Interfering link receiver to evaluate the dRSSInterfering link receiver.

...

Note: You should not confuse the dRSSInterfering link receiver and the dRSSVictim link receiver. Figure 115 illustrates 111 illustrates their differences.

The power control can be input as shown in Figure 141137.

 


Anchor
F141
F141
Figure 141137: Setting up the power control for the interfering link.

Using these assumptions, the results of the simulation are the same as previously since the threshold (-35 dBm) is above the dRSSInterfering link receiver(-37.5 dB). This corresponds to the Case 1 described in ANNEX 14:.

Now, if the threshold is decreased from –35 dBm to –50 dBm (see Figure 142138)

Anchor
F142
F142
Figure 142138: Reduction of the minimum threshold in the PC

Since, the power control feature is activated the gain of the power control is determined according to the guidance given in ANNEX 14: on page 330344. Since the dRSSInterfering link receiver is –37.5 dBm and:

...

                                           iRSSunwanted = -39.5 dBm - git PC  = -49.5 dBm             

...


Finally, if the threshold is decreased from –50 dBm to –70 dBm, the power control feature is activated. Since the dRSSInterfering link receiver is –37.5 dBm, this results in:

...

                                           iRSSunwanted = -39.5 dBm - git PC  = -59.5 dBm

 

...