Anchor | ||||
---|---|---|---|---|
|
Stations FS5 and FS6 in the table 1 70 below have parameters in line with the Rec. ITU-R F.758-5.Also four other representative FS stations FS1, FS2, FS3 and FS4 can be proposed as given in in Table 1. FS1 and FS3 stations are representative of PP FS stations typically deployed, FS2 is representative of a longer than usual link operating in Scotland or Wales where the terrain is mountainous and hence an elevation angle of 5 degrees is appropriate, while FS4 is representative of a P-MP Hub station; P-MP subscriber stations are expected to have parameters similar to those valid for PP stations.
Antenna radiation patterns for FS-PP are usually assumed in sharing studies using the formulas in Recommendation ITU-R F.699 [23] (when a single FS system is considered as victim/interferer) or Recommendation ITU-R F.1245 [24] (when averaging among a number of FS systems as victim/interferer). For P-MP it is recommended to use Recommendation ITU-R F.1336 [25].
Table 6970: Recommended FS characteristics for FS vs FSS studies Anchor T069T070T069 T070
Parameter | FS1 (PP) | FS2 (PP) | FS3 | FS4 | FS5 (PP based on Rec. ITU-R 758-5) | FS6 (P-MP based on Rec. ITU-R 758-5) | Notes |
RX antenna height | 20 m | 20m | 20m | 20m | Not specified, 20m is suggested | Not specified, 20m is suggested |
RX antenna pattern | ITU-R | ITU-R | ITU-R | ITU-R | ITU-R Rec. | ITU-R | Source: |
Receiver noise figure, F | 6 dB | 6 dB | 6 dB | 6 dB | 8 dB | 8 dB | See note (1)[1] |
RX frequency | 28 GHz | 28 GHz | 28 GHz | 28 GHz | 24.25 – 29.50 GHz | 24.25 – 29.50 GHz |
RX elevation angle | 0° | 5° | 10° | 0° | Not specified, 10° is suggested | Not specified, 0° is suggested |
RX peak gain | 45 dBi | 43 dBi | 35 dBi | 18 dBi |
6.5 dBi |
See note (2)[2] |
The Spectrum Mask for P-P and P-MP can be found in EN 302 217-2-2 Annex A (table A4) and ETSI EN 302 326-2 (Section 5.3.4.1) respectively. Blocking information is available from EN 301 390 (Section 7).
...