Versions Compared

Old Version 1

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Anchor
4.5
4.5
In this section the Free Space Model is used to derive the attenuation on the different paths and the Victim Link and Interfering Link operate at the same frequency – 1000 MHz – co-channel interference. Figure 115 presents an illustration of the various radii (i.e. coverage radius and simulation radius) that are used in SEAMCAT and with reference to the various pairs of transmitters and receivers used for a simulation.

Image Added

Anchor
F111
F111
Figure 111: Illustration of the Coverage Radius and the Simulation Radius with respect to the pairs of transmitters and receivers of the victim and interfering links


The distance between the VLT and the VLR is referred to as the coverage radius (

Mathinline
bodyR_{max}^{wt}
) (see ANNEX 13:). In the case of mobile applications, the number of terminals that may transmit in a given cell of the network is given by:

Image Added        (Eq. 25)

The calculation of the coverage radius can be found in ANNEX 13:.

The cluster characterises the frequency re-use of a mobile network (see Figure 112).

Image Added

Anchor
F112
F112
Figure 112: Frequency cluster

The victim link coverage radius (i.e. centred on the victim link transmitter) may then be calculated by using the formula below. Figure 113 presents how to set-up SEAMCAT.


Mathinline
bodyn=den{{s}_{max}}.\pi \ {{\left( R_{max}^{wt} \right)}^{2}}=\frac{{{n}_{channels}}\ .{{n}_{userperchannel}}}{cluste{{r}_{frequency}}}
 (Eq. 26)





 Image Added

Anchor
F113
F113
Figure 113: Calculation of the victim link coverage radius


(Eq. 27)

Image Added




Figure 115 presents the results of the dRSS vector and the results in the coverage radius of the victim link.

The dRSS for a receiver located at the edge of the coverage area may be calculated:

                                           dRSS = 30 (dBm) + 9 + 9 - (32.5 + 10 log(1.43^2) + 20 log(1000)) = -47.5 dBm

 Image Added

Anchor
F114
F114
Figure 114: Resulting dRSS distribution


 Image Added

Anchor
F115
F115
Figure 115: Calculation results of the victim link coverage radius


 Image Added

Anchor
F120
F120
Figure 116: Illustration of the VLR and VLT positioning based on the traffic limited network coverage radius (ILT-red, ILR-green, VLR-yellow, VLT-blue)