Page Comparison

Image RemovedImage Added

Anchor

	6.5.1
	6.5.1

In such a scenario, the detection threshold is taken to a value of 0 dB (Figure 164160) much higher than the sRSS level (average = -82.09 dBm) (Figure 165161). Therefore, no victim system has been detected and the WSDs are allowed to transmit in any of the specified channels (Figure 166162) per event.

Image Added

...

Image Added

...

Anchor

...

Image Removed

Image RemovedFigure 164

	F160

F160

Figure 160: Selection of a high
detection threshold

Anchor

	F161
	F161

Figure

165

161: The sRSS values are well below the

detection threshold, so no victim system have been detected

In such a case the e.i.r.p.used in the simulation is the Tx_power (=-33 dBm) + G_max (=0 dBi), meaning that the in-block e.i.r.p. limit does not apply. This means that whatever the frequency selected by the WSD its e.i.r.p.. is the same (Figure 168164) (here assuming that the Power Control at the It is OFF).

Image Removed

Image Added

Anchor

	F162
	F162

Figure

166

162: The WSD can transmit anywhere

in the victim frequency range

Anchor

	F163
	F163

Figure

167

163: e.i.r.p. set to -33 dBm as set in the It, i.e.

Txpower (=-33 dBm) + Gmax (=0 dBi),

meaning that there were no limit applied to the It Tx power

...

Figure 169 165 illustrates that on average there are 1.17 WSDs active at 1000.5 MHz per event, 1.23 WSDs in 1001.5 MHz, 1.34 WSDs in 1002.5 MHz and 1.26 WSDs in 1003.5 MHz for the same out of 5 which were input to the simulation. In this case all the WSDs were active (but in different frequencies) since the sum equal to 5 (i.e. none of the WSDs have been turned off).