| Anchor | ||||
|---|---|---|---|---|
|
Figure 251: Output vector for the CRAnchor F251 F251
...
Table 5152: Output results for CR simulationAnchor T052 T052
# | Item | Description |
1 | sRSS | sRSS value calculated at the selected WSD frequency (i.e. where the WSD is allowed to transmit) for each of the event |
2 | WSD frequency | The actual selected frequency at which the WSDs are allowed to transmit as the result of the spectrum sensing algorithm |
3 | WSD e.i.r.p. | The actual selected e.i.r.p. at which the WSDs are allowed to transmit as the result of the spectrum sensing algorithm |
4 | Victim frequency | frequency at which the victim device transmits per event |
5 | Average e.i.r.p. per event x active WSDs (for each frequency) | average e.i.r.p. per event for all the active WSDs transmitting at a certain frequency |
6 | Average Active WSD per event (for each frequency) |
...
At the end of the simulation, SEAMCAT provides a set of output vectors as above. Then you can perform the interference probability calculation as previously described.