Versions Compared

Old Version 3

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Anchor
8.3.4
8.3.4
This content of this panel depends whether CDMA system is a victim or an interfering system.  If the CDMA is an interferer, you will have to set the spectrum emission mask and the emissions floor. It is a shared interface with OFDMA.

Image Removed Image Added

Anchor
F193F190F193
F190
Figure 193190: Cellular panel transmitter settings

...


When defining the Emission Mask (not as BEM) the units of the user defined mask are: Offset (MHz); Mask Values (dBc); Reference Bandwidth (kHz).

When defining the Emission mask as a Block Edge Mask (BEM), SEAMCAT sets to 0 dBi the peak gain of the transmitter antenna and uses the power entries of the Mask as e.i.r.p (already including the gain of the antenna). So, if the Emission mask is defiend as BEM, the units of the user defined mask are: Offset (MHz); Mask Values (dBm e.i.r.p.); Reference Bandwidth (kHz).