| Anchor | ||||
|---|---|---|---|---|
|
Figure 23: Illustration of the workspace results (Highest hierarchy level)Anchor F023 F023
In the results workspace,, you are not able It is not possible to edit any of the input fields . You can however in the results tab. It is however possible to select ‘Export workspace’ , to generate and open a new workspace scenario entitled ‘Exported Workspace xyz‘ :
|
|---|
|
|---|
Figure 24: Illustration of exporting a results workspace into a scenario workspaceAnchor F024 F024
The results workspace consists of the following tabs depending on the scenario set-up:
- Outline: You can see the The outline of the simulation can be seen with both a summary of the dRSS and iRSS calculation and a graphical overview of the Tx/Rx positions for the victim and interferer(s);
- Results: You have gives access to a list of all results generated by SEAMCAT and from the EPPs used in the simulation;
- Interference calculations: You are able to use It gives access to the Interference calculation engine;
- CDMA Capacity Finding: This panel is only available when a CDMA system is used in the scenario. It indicates the non-interfered capacity (i.e. number of UEs) when the network is gradually filled up with UEs while measuring a specific system outage depending on uplink (UL) or downlink (DL) configuration;
- Cellular Structure: This panel is only available when a cellular system (CDMA or OFDMA) is used in the scenario. It shows the results of the cellular specific simulation – i.e. layout of the cells, position of users and indication of dropped users.
Figure 25: Results workspace with a Cellular system (the “CDMA capacity finding” is only available with CDMA simulation)Anchor F025 F025
...