Page Comparison

Anchor
4.5 4.5

In this section the Free Space Model is used to derive the attenuation on the different paths and the Victim Link and Interfering Link operate at the same frequency – 1000 MHz – co-channel interference. Figure 115 presents an illustration of the various radii (i.e. coverage radius and simulation radius) that are used in SEAMCAT and with reference to the various pairs of transmitters and receivers used for a simulation.

Image RemovedImage Added

Anchor
F111 F111

Figure 115111: Illustration of the Coverage Radius and the Simulation Radius with respect to the pairs of transmitters and receivers of the victim and interfering links

...

The distance between the VLT and the VLR is referred to as the coverage radius (Image Removed

Mathinline
body R_{max}^{wt}

) (see ANNEX 13:). In the case of mobile applications, the number of terminals that may transmit in a given cell of the network is given by:

                                                                                                                          (Eq. 25)

The calculation of the coverage radius can be found in ANNEX 13:.

The cluster characterises the frequency re-use of a mobile network (see Figure 116112).

Anchor
F112 F112

Figure 116112: Frequency cluster

The victim link coverage radius (i.e. centred on the victim link transmitter) may then be calculated by using the formula below. Figure 117´presents 113 presents how to set-up SEAMCAT.

Mathinline

 

Image Removed

body n=den{{s}_{max}}.\pi \ {{\left( R_{max}^{wt} \right)}^{2}}=\frac{{{n}_{channels}}\ .{{n}_{userperchannel}}}{cluste{{r}_{frequency}}}

 (Eq. 26)

 Image Added

...

Anchor

...

F113

...

F113

Image Removed

Figure 117113: Calculation of the victim link coverage radius

...

(Eq. 27)

Image Added

Figure 119 115 presents the results of the dRSS vector and the results in the coverage radius of the victim link.

The dRSS for a receiver located at the edge of the coverage area may be calculated:

                                           dRSS = 30 (dBm) + 9 + 9 - (32.5 + 10 log(1.43^2) + 20 log(1000)) = -47.5 dBm

...

Image Removed

 Image Added

Anchor
F114 F114

Figure 118114: Resulting dRSS distribution

Image Removed 

...

Image Added

Anchor
F115 F115

Figure 119115: Calculation results of the victim link coverage radius

 Image Added

Anchor
F120

Image Removed

F120

Figure 120116: Illustration of the VLR and VLT positioning based on the traffic limited network coverage radius (ILT-red, ILR-green, VLR-yellow, VLT-blue)

...