...
| Mathinline | ||
|---|---|---|
|
Figure
...
120 presents the GUI with the input value.
...
Settings in the System tab | Settings in the Scenario tab |
|
|
Anchor
...
F120
...
Figure F120
...
120: Setting up the simulation radius in SEAMCAT
(Note that the results of the simulation radius is displayed only after running simulation)
...
The simulation radius is calculated by using the following formula:
...
| Mathinline | ||
|---|---|---|
|
In the example of Figure
...
120, this gives:
...
| Mathinline | ||
|---|---|---|
|
Figure 125121: iRSS using the simulation radius for 1 active transmitter (R=0.178)Anchor F125F121F125 F121
Figure 126122: Calculated simulation radius with 1 active transmitterAnchor F126F122F126 F122
Then for a single interefering link transmitter located at the edge of the simulation radius (R = 0.178 km), the iRSSunwanted may be calculated:
...
| Mathinline | ||
|---|---|---|
|
...
When increasing the number of active transmitters to 10 (see Figure 127123), the simulation radius becomes:
...
| Mathinline |
|---|
|
Then, for a single interefering link transmitter located at the edge of that simulation radius (R = 0.564 km), the iRSSunwanted resulting from this terminal may be calculated as:iRSSunwanted
| Mathinline | ||
|---|---|---|
|
...
|
If 10 active terminals are located at the edge of the simulation radius, the iRSSunwanted may be calculated in the following way:
...
| Mathinline | ||
|---|---|---|
|
...
Then the iRSSunwanted should be above -24.5 dBm as shown on Figure 128124.
...
Figure 127123: Setting up the simulation radius in SEAMCAT with a different Anchor F127F123F127 F123
number of active transmitters
Figure 128124: iRSS using the simulation radius calculated for 10 active interferers (R=0.564 km)Anchor F128F124F128 F124
Anchor F129F125F129 F125
Figure 129125: Calculated simulation radius with 10 active transmitters
...