...
The corresponding power may derived using the known equation:
(Eq. 20)
Unit body P(dBm/Bref)=Pe (dBm)+Att(dBc/Bref)
...
Then, in this example, outside the emission bandwidth (offset between –0.1 MHz and -1 MHz and between 0.1 MHz and 1 MHz), the power is equal to:
| Unit | ||
|---|---|---|
|
The complete unwanted emission mask is provided in the below figure.
Figure 99: Unwanted emission maskAnchor F103F099F103 F099
...
Using the previous assumptions, it is possible to derive the interfering power received by the Victim link receiver within its bandwidth as described in ANNEX 5: on page 274. This is called the iRSSunwanted:
...
(Eq. 21)
Unit body iRSSunwanted = P + Ge + Gr - L
...
| Unit | ||
|---|---|---|
|
...
| Unit | ||
|---|---|---|
|
...
|
...
This can be checked by running a simulation and displaying the iRSSunwanted signal as depicted in Figure 100.
Figure 100: Mean iRSSunwantedAnchor F104F100F104 F100
In this example there is no bandwidth correction factor to be applied to the calculation of the iRSSunwanted since the VLR bandwidth and the ILT reference bandwidth have the same value (i.e. 200 KHz).
Examples of correction bandwidth can be found in section 3.3.8