Page Comparison

Anchor
4.5 4.5

In this section the Free Space Model is used to derive the attenuation on the different paths and the Victim Link and Interfering Link operate at the same frequency – 1000 MHz – co-channel interference. Figure 115 presents an illustration of the various radii (i.e. coverage radius and simulation radius) that are used in SEAMCAT and with reference to the various pairs of transmitters and receivers used for a simulation.

Image RemovedImage Added

Anchor
F115F111F115 F111

Figure 111: Illustration of the Coverage Radius and the Simulation Radius with respect to the pairs of transmitters and receivers of the victim and interfering links

...

The cluster characterises the frequency re-use of a mobile network (see Figure 112).

Anchor
F116F112F116 F112

Figure 112: Frequency cluster

The victim link coverage radius (i.e. centred on the victim link transmitter) may then be calculated by using the formula below. Figure 113´presents 113 presents how to set-up SEAMCAT.

Mathinline
body n=den{{s}_{max}}.\pi \ {{\left( R_{max}^{wt} \right)}^{2}}=\frac{{{n}_{channels}}\ .{{n}_{userperchannel}}}{cluste{{r}_{frequency}}}

 (Eq. 26)

Image Removed Image Added

Anchor
F117F113F117 F113

Figure 113: Calculation of the victim link coverage radius

...

(Eq. 27)

Image Added

Figure 119 115 presents the results of the dRSS vector and the results in the coverage radius of the victim link.

The dRSS for a receiver located at the edge of the coverage area may be calculated:

                                           dRSS = 30 (dBm) + 9 + 9 - (32.5 + 10 log(1.43^2) + 20 log(1000)) = -47.5 dBm

Image Removed Image Added

Anchor
F118F114F118 F114

Figure 114: Resulting dRSS distribution

Image Removed Image Added

Anchor
F119F115F119 F115

Figure 115: Calculation results of the victim link coverage radius

 

Anchor
F120 F120

Figure 116: Illustration of the VLR and VLT positioning based on the traffic limited network coverage radius (ILT-red, ILR-green, VLR-yellow, VLT-blue)

...