Versions Compared

Old Version 3

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Anchor
A13.2.2
A13.2.2
In the mode uniform density, Rsimu defines the circular area where the ILTs are spread. The Rsimu in the ILT-VLR path is calculated at the very beginning of a simulation and applied in all events. It is defined as: 

                                   Image Removed                         (Eq. 169                

Mathinline
body${{R}_{simu}}=\sqrt{\frac{{{n}^{active}}}{\pi \ \times \ dens_{ILT}^{active}}}$
   (Eq. 178)

 

densitactive  isthe density of active transmitters and is defined as follows:


     

...

                                Image Removed                         (Eq. 170                 

Mathinline
body$den{{s}_{ILT}}^{active}=den{{s}_{ILT}}.{{p}_{ILT}}.activit{{y}_{ILT}}(time)$
   (Eq. 179)

where:

    • nactive - number of active transmitters set in the scenario for IT-VR path (note htat that nactive should be sufficiently large so that the (n+1)th interferer would contribute with a negligible additional interfering power); 
    • densit - density of transmitters, 1/km2, user-defined parameter in the table Interferers density of ILT-VLR path;
    • Pit - probability of transmission, user-defined parameter;
    • activityit(time) - user-defined temporal activity function (i.e. look-up table). The time value used for calculation is specified in the parameter time (see below). 
    • time - parameter defining which of the values in the above activity function should be used in calculations (e.g. if the activity(time) function contains three pairs: (1;0.5), (2;0.7), (3; 0.9) and the time parameter is set to 2, then the activity(time) function will return a value 0.7). 

 


In case a fixed simulation radius with a defined density of active users is provided, the number the nactive  users can be evaluated by using the following equation, which is derived from the above equation.

Mathinline
body${{n}_{active}}=den{{s}_{transmitter}}.

...

Image Removed                            

pro{{b}_{transmission}}.\pi \ {{\left( R_{simulation}^{{}} \right)}^{2}}$
  (Eq. 171180)

...


When setting up your simulation, if the relevant input parameter is the simulation radius, it is recommended to use the mode “None” instead of the “Uniform density” mode. In that case, the activity of the transmitter may be simulated using  e.g. the parameter duty cycle, which defines a distribution of the transmit power.

...