Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Anchor
2.7
2.7
A simulation is started when you click clicking on the Start button of SEAMCAT toolbar in the simulation control part of the Scenario tab  ( ). The simulation starts and all other commands/buttons are, meanwhile, disabled except the stop button ( ). SEAMCAT automatically performs the consistency check of the scenario parameters before starting the event generation (see Section ‎2.9).

The simulation runs until the number of events has been performed or if you stop the simulation is stopped prematurely by pressing the stop button. 

Image Removed Image Added

Anchor
F032
F032
Figure 32: Menu bar during run time. You can stop the simulation at anytime Simulation control  window in the scenario tab