This panel consists in setting of the emission characteristics of your generic system.
Table 14: Emission characteristics GUI
Description | Symbol | Type | Unit | Comments |
Power | P | Scalar or Distribution | dBm | This is the transmitter power supplied of the generic system. |
Interfere is CR: | Boolean | When the CR button is checked then it allows to set the emission characteristics of the VLT and ILT (used for the sRSS calculation only. See Section 6). | ||
Emission mask: | emission_rel(f) | Function (X,Y) (MHz) | dBc/ reference bandw. (MHz) | Define the mask of the transmitter, in the emission bandwidth and out of the emission bandwidth. It is the unwanted signal level from the ILT (See ANNEX 7:). |
Unwanted emissions floor: Noise floor signal level | emission_floor(f) | Function (X,Y) (MHz) | dBm/ reference bandw. (MHz) | Define the minimum strength of the unwanted emissions. So the unwanted emissions equal to Max(PTx + Unwanted emission, Unwanted emissions floor) (see Annex A7.4). |
Power control | If Power control is checked, the 3 following parameters have to be defined. This Power control is used to limit the output power of the transmitter (see ANNEX 14:). | |||
Power control step size | PC step | Scalar | dB | |
Min threshold | PC threshold | Scalar | dBm/ emission bandw | If the received power is lower than this threshold, then no power control takes place. |
Dynamic range | PC dyn | Scalar | dB | If the received power is higher than Pc treshold + Pc dyn then the full power control takes place, i.e. the power is decreased by Pc dyn. |
A 2010 version of the manual for the cogintive radio module can be downloaded here.